x
I
n
k
a
r
p
BWB Flash Flame Photometer
BWB Flash Flame Photometer
Finally, a Flame Photometer specific to your needs. The first simultaneous Flame Photometer with built in compressor and configurable element analysis to your requirements.
- Large 5" touch screen display compatible with the majority of disposable laboratory gloves
- True ease of use with large buttons and simple to understand text and symbols
- Built-in air compressor and gas regulator
- Calibration standards supplied as standard in 10,000ppm concentrations
- Auto-read technology enables operator independent determination of results
- User selectable decimal places
- IQ, OQ, PQ we-based certification available: iq oq pq is completely unique to the analytical instrumentation arena. Available in english, russian, german, mandarin, french and spanish. More languages in development
- Complete set of basic labware included to get you started
| Sample rate | 2 – 3.5ml/min | ||||
|---|---|---|---|---|---|
| Tubing materials | Silicone and Tygon® | ||||
| Required desk space for Instrument | 101*cm (H) x 45cm (W) x 35cm (D) For Safety reasons the Flame photometer requires 1m of unobstructed space above to allow dissipation of heat from the chimney. |
||||
| Instrument size | Flash Photometer 51cm (H) x 33cm (W) x 35cm (D) (20in x 13in x 14in) |
||||
| Shipping | 65cm (H) x 49cm (W) x 43cm (D) (25in x 19in x 17in) |
||||
| Weight | Flash Photometer – 10kg (22.1lbs) Shipping – 18kg (39.7 lbs)* *subject to vary based on accessories included |
||||
| Optimal | Single point calibration Na 0.1 – 60ppm K 0.05 – 100ppm Li 0.05 – 50ppm Ca 1.0 – 100ppm Multi Point Calibration Na 0.1 – 1000ppm K 0.05 – 1000ppm Li 0.05 – 1000ppm Ca 1.0 – 1000ppm |
||||
| Reproducibility | < 1% Coefficient of variability for 20 consecutive samples over ten minutes at concentrations of 100ppm or less. (After instrument stabilisation). | ||||
| Specificity | Na/K/Li = <1% to each other when equal in concentration at <100ppm | ||||
| Limit of detection (LOD) and limit of quantification (LOQ) |
|
||||
| Time to stability | Less than 15 seconds after sample is introduced into the flame. | ||||
| Ions measured | Simultaneous measurement of model specific elements | ||||
| Interfaces | USB 0-2.5 volt output (based on sample concentration linked to element of users choice) Optional 4-20mA output in place of the above Optional integrated printer .csv and .pdf generated reports and files via FP-PC software |
||||
| Recommended minimum warm up time based on ambient temperature | 21ºC – 25 minutes | ||||
| Power requirements | 100V – 250V AC at 50 or 60Hz automatically selecting | ||||
| Fuel requirement | Propane, Butane or Natural Gas* regulated to 19Bar. Flow rate of 0.4l/min | ||||
| Fuel requirement | Propane, Butane or Natural Gas* regulated to 19Bar. Flow rate of 0.4l/min *with modifications. BWB Technologies recommends either Propane or Butane for optimum results. |
||||
| Readout | 5" colour capacitive touch screen display |